‼ NOTE
• The equipment is most stable when it is
as low to the floor as possible. Therefore,
start to level the equipment by turning all
support feet fully in, before turning out the
required support feet to stabilize and level
the equipment.
Adjusting the horizontal seat position
The horizontal seat position can be adjusted by
setting the seat to the required position.
- Loosen the seat adjustment knob.
- Move the seat to the required position.
- Tighten the seat adjustment knob.
Adjusting the vertical seat position
The vertical seat position can be adjusted by
setting the seat tube to the required position.
With the leg almost straight, the arch of the foot
must touch the pedal at its lowermost point.
- Loosen the seat tube adjustment knob.
- Move the seat tube to the required position.
- Tighten the seat tube adjustment knob.
Adjusting the handlebar
The handlebar can be adjusted according to the
height and the exercise position of the user.
- Loosen the handlebar adjustment knob.
- Move the handlebar to the required position.
- Tighten the handlebar adjustment knob.
Emergency break knob
To apply the brake, press down on the brake
tension
knob.
Power supply (Fig� E)
The trainer is powered by an external power
supply. Refer to the illustration to locate the
trainer power input.
‼ NOTE
• Connect the power supply with the trainer
before connecting it to the wall outlet.
• Always remove power cord when
• machine is not in use.
Warranty
Tunturi purchaser‘s warranty
Warranty terms
The consumer is entitled to the applicable legal
rights stated in the national legislation concerning
the commerce of consumer goods. This warranty
does not restrict these rights. The Purchaser’s
Warranty is only valid if the item is used in an
environment approved by Tunturi New Fitness BV,
and is maintained as instructed for that particular
equipment. The product-specific approved
environment and maintenance instructions are
stated in the “user manual” of the product. The
“user manual” can be downloaded from our
website. http://manuals.tunturi.com
Declaration of the manufacturer
Tunturi New Fitness BV declares that the product
is in conformity with the following standards and
directives: EN 957 (HB), 2014/30/EU . The product
therefore carries the CE label.
04-2020
Tunturi New Fitness BV
Purmerweg 1
1311 XE Almere
The Netherlands
Disclaimer
© 2020 Tunturi New Fitness BV
All rights reserved.
- The product and the manual are subject to
change.
- Specifications can be changed without further
notice.
- Check our website for the latest user manual
version.
16
English
Summary of Contents for 17TBS40000
