Tunturi 18TCFD2000 User Manual Download

Page: 14 / 48

1 4

English

Replacing the battery

When you have troubles pairing the console we recommend to
replace the CR2032 battery in the transmitter housing�

OFF

CR2032 x1

Console

The console for this bike is optional and can be purchased as an
additional part, but is not required�
The additional console can be paired via the build in radio
transmitter�

‼ NOTE

• If you do not wish to purchase the additional console we

recommend you to remove the battery from the transmitter
housing�

- The radio transmitter is located under the resistance adjustment

knob�

- The radio transmitter is equipped with a switch to turn the

transmitter in on or off mode�

- The console will automatically receive the transmitter signal when

setting the transmitter in on mode�

Cleaning and maintenance
The equipment does not require special maintenance� The
equipment does not require recalibration when it is assembled, used
and serviced according to the instructions�

⚠ WARNING

•  Do not use solvents to clean the equipment�
•  Clean the equipment with a soft, absorbent cloth after each use�
•  Regularly check that all screws and nuts

are tight�

• If necessary, lubricate the joints�

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment� In most cases, it will
be sufficient to replace the defective part�

- If the equipment does not function properly, immediately contact

the dealer�

- Provide the model number and the serial number of the equipment

to the dealer� State the nature of the problem, conditions of use
and purchase date�

Trouble shooting:

- When the display of LCD is dim, it means the batteries need to be

changed�

- If there is no signal when you pedal, please check if the cable is

well connected�

‼ NOTE

• When stop training for 4 minutes, the main screen will be off�
• If the computer displays abnormally, please re-install the

batteries and try again�

Transport and storage

⚠ WARNING

• Carry and move the equipment with at least two persons�
• Move the equipment and carefully put the equipment down�

Place the equipment on a protective base to prevent damage to
the floor surface�

• Move the equipment carefully over uneven surfaces� Do not

move the equipment upstairs using the wheels, but carry the
equipment by the handlebars�

• Store the equipment in a dry place with as little temperature

variation as possible�

Additional information

Packaging disposal

Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites� We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres�

End of life disposal

We at Tunturi hope you enjoy many years of enjoyable use from
your fitness trainer� However, a Time will come when your fitness
trainer will come to the end of its useful life� Under ‘European WEEE
Legislation you are responsible for the appropriate disposal of your
fitness trainer to a recognised public collection facility�

Technical data

Parameter

Unit of
measurement

Value

HR� receiver

handgrip contact
5�3 ~ 5�4 Khz��
Bluetooth (BLE)
ANT+



Length

cm
inch

80�5
31�7

Width

cm
inch