Tunturi 8717842028261 User Manual Download

Page: 16 / 60

1 6

English

- Press MODE to select goal you like to set. (the selected goal will

blink when able to set value.)

Press SET Button to higher the goal input, hold SET button to
higher the value fast.

- Press RESET button shortly to reset the changed selected goal.

- Press MODE Button to active next optional goal to be set.

TIME + 1 min

( 1 ~ 99)

SPEED

( max. 99,9 Km/h)

DIST + 0,5KM ( 0,5KM ~ 99,50Km )

ODO

( max. 999,9 Km)

CAL + 1

( 1 ~ 999 )

PULSE + 1

( 40 ~ 240 )

‼ NOTE

•

When you set a goals the set goal value will Count down in

active mode.

•

When goal is reached the console will notify by 4 dual acoustic
beep signals. The reached value will now Count up starting from

“0”.

•

You can set more than one goal, all goals will notify when goal

is reached.

RESET

Push and hold for 4 seconds to reset: Time, Dist., Cal., & Pulse

‼ NOTE

•

Total Count can only be reset by a batteries exchange.

Extra notes

If the display is faint or shows no figures, please replace the

batteries.

The monitor will automatically shut off if there is no signal received
after 4 minutes .

- The monitor will be auto-powered on when starting to exercise

push button w/signal in.

- The monitor will automatically start calculating when you start to

exercise and will stop calculating when you stop exercising for 4

seconds .

Cleaning and maintenance

The equipment does not require special maintenance. The
equipment does not require recalibration when it is assembled, used

and serviced according to the instructions.

⚠ WARNING

•

Do not use solvents to clean the equipment.

•

Clean the equipment with a soft, absorbent cloth after each use.

• Regularly check that all screws and nuts

are tight.

•

If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment. In most cases, it will
be sufficient to replace the defective part.

If the equipment does not function properly, immediately contact

the dealer.

Provide the model number and the serial number of the equipment
to the dealer. State the nature of the problem, conditions of use

and purchase date.

Trouble shooting:

When the display of LCD is dim, it means the batteries need to be

changed.

If there is no signal when you pedal, please check if the cable is

well connected.

‼ NOTE

•

When stop training for 4 minutes, the main screen will be off.

•

If the computer displays abnormally, please re-install the

batteries and try again.

Transport and storage

⚠ WARNING

•

Carry and move the equipment with at least two persons.

•

Move the equipment and carefully put the equipment down.
Place the equipment on a protective base to prevent damage to
the floor surface.

•

Move the equipment carefully over uneven surfaces. Do not
move the equipment upstairs using the wheels, but carry the
equipment by the handlebars.

•

Store the equipment in a dry place with as little temperature

variation as possible.

Additional information

Packaging disposal

Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites. We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres.

End of life disposal

We at Tunturi hope you enjoy many years of enjoyable use from
your fitness trainer. However, a Time will come when your fitness
trainer will come to the end of its useful life. Under ‘European WEEE
Legislation you are responsible for the appropriate disposal of your
fitness trainer to a recognised public collection facility.

Technical data

Parameter

Unit of
measurement

Value

Length

cm
inch

84.0
30.7

Width

cm
inch

50.0
19.7

Height

cm
inch