20
English
Power off
Without any signal being transmitted into the
monitor for 4 minutes the monitor will enter
SLEEP mode automatically. ( Active training data
will be lost )
Programs
Manual mode
- Select “Manual” and confirm by pressing
“Enter”
- Set your training target for “Time, Distance,
Strokes Calories and Pulse” by using the “Up/
Down” keys and confirm with Enter.
- Press “Start/ Stop” button to start the setup
training.
‼ NOTE
• Only one target can be set, the not set
targets should be confirmed as “0” goal
target.
• Pulse is not a trainings ending target, but
only set as warning.
• When set a target, the training will end when
target is reached.
• If no target is set, the training will continue
until user ends training.
Race mode
- Press mode button to select “Race Mode” and
confirm by pressing “Enter”.
- L9 will be displayed, use Up/ Down key to set
required “Race mode” level, and confirm with
“Enter”.
Displayed “Time/ 500 is the PC time you need
to beat.
Mode
Time/ 500
Mode
Time/ 500
L1
8:00 min
L9
4:00 min
L2
7:30 min
L10
3:30 min
L3
7:00 min
L11
3:00 min
L4
6:30 min
L12
2:30 min
L5
6:00 min
L13
2:00 min
L6
5:30 min
L14
1:30 min
L7
5:00 min
L15
1:00 min
L8
4:30 min
- Set desired training distance (± 500 mtr) and
confirm with “Enter”
- Press “Start/ Stop” button to start a 3 seconds
countdown prior to your training start.
‼ NOTE
• Training will end, when computer (PC) or you
(User) has reached the end first.
• Console will display “User win” or “PC win”
when you or computer reaches the end first,
and stops training.
Cleaning and maintenance
The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent
cloth after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.
Water changes color or becomes
cloudy
Possible cause:
Rower is in direct sunlight or has not had water
treatment.
Solution:
- Change rower location to reduce direct
exposure to sunlight.
- Add water treatment or change tank water as
directed in the water treatment section of this
manual.
Replacing the batteries (fig. F-2)
The console is equipped with 2 AA batteries at
the rear of the console.
- Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity markings.
- Mount the cover.
Summary of Contents for Cardio Fit R60w
