Tunturi FitCycle 30, User Manual

1 7

English  

Remark: During the process of pulse measurement, 

because of the contact jamming, the measurement 

value may be higher than the virtual pulse rate during 

the first 2~3 seconds, then will return to normal level. 

The measurement value cannot be regarded as the 

basis of medical treatment. 

NOTE

•  If the display is faint or shows no figures, please 

replace the batteries. 

•  The monitor will automatically shut in standby 

mode if there is no signal received after 4 

minutes.

•  The monitor will be auto-powered on when 

starting to exercise or at the push of a button.

•  The monitor will automatically start calculating 

when you start to exercise and will stop 

calculating when you stop exercising for 4 

seconds. 

Specifications:

Function

-

Auto scan   

Every 4 seconds

-

Time 

0:00 ~ 99:59

-

Current speed 

The maximum speed to be 

displayed is 99,9 KM/H

-

Trip Distance 

0.00 ~ 99.99 KM

-

Calories 

0.0 ~ 999.9 K.Cal

-

ODO 

0.1 ~ 999.9 KM

-

Pulse rate  40 ~ 240 BPM

Operating Temperature 0°C ~ +40°C 

Storage Temperature  -10°C ~ +60°C

Extra notes

-

If the display is faint or shows no figures, please 

replace the batteries.

-

The monitor will automatically shut off if there is no 

signal received after 4 minutes .

-

The monitor will be auto-powered on when starting 

to exercise push button w/signal in.

-

The monitor will automatically start calculating 

when you start to exercise and will stop calculating 

when you stop exercising for 4 seconds .

Cleaning and maintenance

The equipment does not require special maintenance. 

The equipment does not require recalibration when 

it is assembled, used and serviced according to the 

instructions.

WARNING 

•  Do not use solvents to clean the equipment.

•  Clean the equipment with a soft, absorbent cloth 

after each use.

•  Regularly check that all screws and nuts  

are tight.

•  If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and 

malfunctions caused by individual parts can occur in the 

equipment. In most cases, it will be sufficient to replace 

the defective part.

-

If the equipment does not function properly, 

immediately contact the dealer.

-

Provide the model number and the serial number of 

the equipment to the dealer. State the nature of the 

problem, conditions of use and purchase date.

Transport and storage

WARNING

•  Carry and move the equipment with at least two 

persons.

•  Remain standing in front of the equipment 

on each side and take a sturdy grip at the 

handlebars. Tilt the front of the equipment 

so as to lift the rear of the equipment on the 

wheels. Move the equipment and carefully put 

the equipment down. Place the equipment on a 

protective base to prevent damage to the floor 

surface.

•  Move the equipment carefully over uneven 

surfaces. Do not move the equipment upstairs 

using the wheels, but carry the equipment by the 

handlebars.

•  Store the equipment in a dry place with as little 

temperature variation as possible.

Additional information

Packaging disposal

Government guidelines ask that we reduce the amount 

of waste material disposed of in land fill sites. We 

therefore ask that you dispose of all packaging waste 

responsibly at public recycling centres.