Tunturi Pure 3.1, User Manual

GB

O W N E R ’ S   M A N U A L

•

P U R E   R U N   3 . 1

11

MAINTENANCE

The equipment is safe to use only when 

periodically maintained and inspected 

for faults and wear. 

CAUTION!

Do not attempt any servicing or 

adjustment other than those described 

in this manual. Any other servicing must 

be performed by an authorized service 

representative. Check the tightness of 

all fixing screws once a year. Do not 

overtighten.

CLEANING AND LUBRICATING THE 
TREADMILL

FA I L U R E   TO   L U B R I C AT E  Y O U R 

T R E A D M I L L  M AY  I N VA L I D AT E   T H E 

P R O D U C T ’ S   WA R R A N T Y !

Wipe the treadmill surfaces, especially 

the handlebars and console from dust 

with a damp cloth or towel. Do not 

use solvents. Use a small vacuum 

nozzle to carefully vacuum around all 

visible components (belt, running deck, 

side rails etc.). Also keep the area 

near the treadmill clean. While in use, 

the treadmill gathers dust that may 

cause problems in the operation of the 

equipment.

In average domestic use (60 minutes a 

day), you should check the lubrication 

once a month – however, lubricate the 

belt only if needed. In more demanding 

use, the lubrication needs be checked 

at shorter intervals. This is best done 

before you begin a training session. 

Check the lubrication as follows:

•  Ensure the treadmill is powered off!

•  Step on the treadmill belt .and stand 

steadily where you normally run on 

the belt.

•  Take hold of the horizontal handlebar 

and push the belt with your feet so 

that it slides back and forth.

•  The belt should move softly and 

evenly, without a sound.

If you notice jerky movement or if the 

belt will not slide check for lubrication by 

sliding your hand under the belt.

LUBRICATE THE RUNNING DECK 
ACCORDING TO THE FOLLOWING 
INSTRUCTIONS:

1.  Attach the nozzle of the lubrication 

tube to the T-Lube S container.

2.  Lift the running deck and lock it.

3.  Position the nozzle between the belt 

and the board. Try to reach the spray 

as far into the center of the running 

deck as possible.

4.  Spray the lubricant for 2-3 seconds.

5.  Lower the running deck into its 

normal position. Use treadmill for 

your training session. Or allow the 

treadmill to run for at least 5 minutes 

at 5KM/H ( 3Mile/H).

NOTE! 

Lubricate your treadmill only with T-Lube 

S silicon lubricant. Contact your local 

Tunturi distributor for further supplies 

of T-Lube or further information on 

lubrication and maintenance.

User manual Tunturi Style-Treadmill Run 3.1 20140310.indd   11

02/04/2014   20:24:21