GB
O w n e r ’ s m a n u a l • P u r e R o w 8 . 1
15
NOTE
You will hear the velcro separating just
before the belt detaches.
Re-attaching the
rowing belt
• Begin re-attaching by guiding the
rower belt around the rower belt
pulley.
• The velcro side should be facing
upward as illustrated.
• Next, guide the belt around the idle
wheel as shown.
• Once around the idle wheel, attach
the rower belt to the belt / bungee
pulley. There is an obvious “lip” at the
attachment point.
• Wind the rower belt onto the belt /
bungee pulley until the rower handle
is at its furthest forward position.
Change of bungee
cord
• 6. Rethread the bungee cord
(on opposite side of the idle wheel)
back through the bungee pulleys and
tie off at the attachment point.
Bungee cord route (red line)
NOTE
• If bungee cord previous tension
seemed correct (a good way to judge
is if the rower handle can make it
to the furthest point forward on the
top of the mainframe under bungee
tension alone) then simply tie off at
previous position.
• If the return is too slack, experiment
