To stop the equipment:
1. Set the mains power switch to the off position.
2. Remove the mains plug from the wall socket.
3. Remove the mains plug from the equipment.
Safety key (fig. E)
The equipment is equipped with a safety key that must be properly inserted into the
console to start the equipment. If you remove the safety key from the console, the
equipment will stop immediately.
1. Insert the safety key into the slot in the console.
2. Make sure that the clip of the safety key is properly attached to your clothing.
Make sure that the clip is not removed from your clothing before the safety key is
removed from the console.
Circuit breaker
The equipment is equipped with a circuit breaker that interrupts the circuit when the
electricity load is above the maximum capacity. When this occurs, the circuit breaker
must be pressed.
WARNING
– Before pressing the circuit breaker, remove the mains plug from the
equipment.
If the equipment shuts down, proceed as follows to restart the equipment:
1. Remove the mains plug from the equipment.
2. Press the circuit breaker to restart the equipment.
3. Insert the mains plug into the equipment.
Adjusting the support feet
The equipment is equipped with 4 support feet. If the equipment is not stable, the
support feet can be adjusted.
1. Turn the support feet as required to put the equipment in a stable position.
2. Tighten the locknuts to lock the support feet.
EN
16
RUN 6
.1
Summary of Contents for Pure Run 6.1
