6
Owner
’s manual
•
PURE 10.1
General assembly information
WARNING
• Assemble the equipment in the given
order.
• Carry and move the equipment with
at least two persons.
CAUTION
• Place the equipment on a firm, level
surface.
• Place the equipment on a protective
base to prevent damage to the floor
surface.
• Allow at least 100 cm of clearance
around the equipment.
Refer to the illustrations for the correct
assembly of the equipment.
Assembly steps
Assembly step A
• Fit front stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step B
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step C
• Connect the wires from upright tube
and main frame before sliding the
upright tube in position.
Remark:
Do not remove screws from the frame
before siding the upright tube in position.
• Use the enclosed Allen key to tighten
both fastening screws through the
holes in the tube from inside out.
• Tighten the fastening screws by
turning them counter-clockwise.
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
Summary of Contents for Pure U bike 10.1
