11
applications only.
•
Do not operate in close proximity to walls, curtains, or other objects that may block
inlet and outlet.
•
Keep the air inlet and outlet free of obstacles.
•
Adjusting the wind deflector in the upward direction prior to start up.
•
If tipped more than 45°, allow the unit to set upright for at least 24 hours before start
up.
•
Keep doors and windows close for better energy saving.
•
Do not operate or store the unit in direct sunlight or rain.
•
It is normal for air outlet to feel warm to touch after continuous operation on hot
days.
•
Empty the water tank before moving the device.
•
Make sure the Water tank is correctly fitted otherwise the unit will not operate
properly.
•
The dehumidifier starts up in the mode selected when the unit was last used.
•
The dehumidifier starts dehumidifying if the room humidity is 3% higher than the
selected humidity.
•
There is a protective 3-minutes time delay of the compressor. Wait 3 minutes for the
dehumidifier to resume dehumidification.
5. OPERATION
A.
3-colour Humidity LED on the front of the unit
Blue LED indicator
– humidity level in the room is lower than 45%
Green LED indicator
– humidity in the room is between 45% and 65%
Red LED indicator
– humidity level in the room is higher than 65%
B.
Control Panel
POWER
In the standby state, press the power button to turn on, the operation indicator
lights up and the default fan speed is high, and the default humidity is 50%. In the
power-on state, press the power button to turn off, the running indicator light goes off and
the compressor stops immediately, and then the fan shut down after 30 seconds delay.
Summary of Contents for SENSO 12
Page 108: ...www turbionaire com...
