Turbo Air TB-4, Installation And Operation Manual

4

PACKAGING MATERIAL

LIGHTS

SHELVES

Remove all tape that holds life up glass and doors in place. Some residue will be left
and this can be removed with glass cleaner.

Remove all plastic ties that hold shelves and brackets for shelves.

Make sure lights are in their lamp holders. Also make sure plugs for lamp holders are
completely plugged in. If they are loose it may cause lamp holder to burn.

To install shelves in desired position front glass must be open and rear doors removed.

Remove doors by lifting upwards and then out of bottom track one at a time.
Put doors in a safe location. Lift front glass upwards till fully open.

Where shelf height is desired install the shelf support in shelf standard slot (see drawing).

Install shelves on rear shelf support as shown. Curved part of shelf must be toward
front of case if not air flow will be blocked. Snap shelf into retainer clip on the shelf
support, this keeps shel from moving (see drawing).

After installing all shelves close front glass and reinstall doors.