OPERATING INSTRUCTIONS
After installing unit and plugging in unit to correct voltage, Display is ready
to start up.
CONTROLS
LIGHT SWITCH:
It is located on top right hand side by display.
TEMPERATURE CONTROL :
Temperature is preset from factory at
45℉. To reset temperature for another setting, push button that has a bell
for one second and release.
Then press the buttons next to it to raise or lower temperature. Up is for
warmer and down is for colder. After setting temperature, button with bell
needs to be pushed again to set temperature.
THERMOMETER:
Display shows temperature on start up. As it gets
colder it will go lower till it reaches temperature that was set.
NOTE:
Before placing product to display, wait for unit to reach desired temperature.
Do not place hot product in unit.
HOW TO PLACE PRODUCT:
Do not overload product on shelves. Do
not place product against back wall, due to air flow will be blocked and
cause unit not to cool properly.
5
MAINTENANCE & CLEANING
!!! Always before cleaning Display, unit should be turned off at
power switch and lights
should be turned off. Remove product and allow display to reach
room temperature
!!! Do not wet electrical components.
DISPLAY
CASE
SHOULD
BE
CLEANED
THOROUGHLY BEFORE FIRST USE.
a.Do not clean with harsh detergents. Use a mild soap
b.Remove all products.
c. Remove shelves and bottom trays.
d. Clean interior with warm water and mild detergent.
e. Wipe with damp cloth. Do not leave residue of soap.
6
