- 4 -
Turbo Elite:
Stainless Steel Hood Installation
4a.
Remove the Hood Assembly from the carton carefully.
The Top Hinges have been aligned and fastened to the
hood section prior to delivery.
Turbo Classic:
Aluminum-Sided Hood Installation
4b.
Remove aluminum-sided hood from
carton carefully. Assemble hinge
top to hood using stainless steel
bolts, fiber washers, stainless
washers, lock washers and dome
nuts (
Figure 3
).
5.
Place barbecue on a stable flat surface and fit the
Bottom Hinges with Warming Rack Brackets on the
inside of the barbecue frame using the bolts, lock washers,
and nuts provided (
Figure 4
).
DO NOT TIGHTEN NUTS AT THIS STAGE. FINGER
TIGHT IS SUFFICIENT
.
IMPORTANT: IF BARBECUE IS TO BE INSTALLED ON A
CART, ASSEMBLE TO CART PRIOR TO ASSEMBLING
HOOD TO BBQ FRAME TO MAKE CART ASSEMBLY
EASIER
.
6.
Place the hood section onto the barbecue in the closed
position. Align holes on Top and Bottom Hinges and
insert Hinge Pivot Pins into position (you may have to
move the bottom halves of the hinge assemblies to
achieve alignment). Now fit the retaining clips into the
hinge pivot pins (
Figure 4
).
7.
Roll the assembled barbecue and hood onto its back
edge while holding the hood closed with one hand,
tighten the four (4) nuts, securing the hinge and
warming rack bracket with the other hand (
Figure 5
).
8.
If your barbecue is equipped with a rear rotisserie
burner, the bottom hinges are pre-attached to the rear
rotisserie burner mount and there is no need to attach
them.
Warming Rack
Bracket
Figure 4
Hinge
Bottom
Hinge
Pivot Pin
Dome Nut
Hinge Top
Lock
Washer
Retaining
Clip
Hold lid in closed position while tightening nuts.
Figure 5
stainless
washers
fiber washer
lock washer
dome nut
Figure 3
Summary of Contents for CG3TCBN
Page 2: ......
Page 23: ......
Page 24: ...Barbeques Galore z 949 597 2400 z 10 Orchard Road Suite 200 z Lake Forest CA 92630...