PHOTO P
2 1/4"
EASY FLUSH MEASUREMENTS:
PRACTICAL INFORMATIONS
Weight ................73 lbs, 33 Kg
Width ...................± 24 1/4", ± 61 1/2 cm
Length.................± 34", ± 86 cm
Height .................± 20 1/2", ± 52 cm
Base height .......± 5 3/4", ± 14 1/2 cm
Airlock Preventer
Hole 5/8"
5
PHOTO N
PHOTO O
STEP 19
Install your toilet in the desired location with
a wax ring and bolts. Slide the brass screws in
the proper slot position. Hook up the water
line, turn it on and check for leaks. Flush the
toilet and allow the pump to cycle and insure
a proper operation. Toilets with less than a 1.6
gallon flush are not recommended for use in
our "EASY FLUSH" System. For a better
performance and to create a better water flow,
it is recommended that the unit is flushed twice,
from time to time.
STEP 20
Cut another short piece of foam seal (3 3/4")
and glue it to the appropriate space inside the
lid of the tank. (
Photo N
)
STEP 21
After completing the pump installation, fix
the lid using the bolts. This will seal the wires.
Fasten the top lid by using screws and washers.
(
Photo O
)
STEP 22
"
OPTION
"
To install an additional shower or sink
unit to the "Easy Flush" System, use the
additional 2" "Aqua Flex" gasket. The extra
fixture piping must be installed on the
same side as the illustration (Photo P) to
prevent direct water flow on pump switch.
Drill a 3" hole on the illustrated side of the
basin.
It is mandatory to connect the
piping above the base of the unit
(
Photo P
), to prevent any waste water
back flow in the additional fixtures.
It’s also required that the center of the
gasket hole should not be less than 2 1/4"
from the base.
Failure to drill the 3" hole in
proper location will void the unit warranty.
It is also recommended that if you hook up
more than one fixture, that these two or more
be connected to the same discharge piping.
Each additional unit must also be vented.
Summary of Contents for T40040
Page 12: ...NOTES ...
