Turboair Ticino, Instruction On Mounting And Use Manual

15 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Fig. 10-25 
Traps cooking grease particles. 

The grease filter

 must be cleaned once a month using non 

aggressive detergents, either by hand or in the dishwasher, 
which must be set to a low temperature and a short cycle.  
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 24 
It absorbs unpleasant odours caused by cooking. 

The saturation of the charcoal filter occurs after more or less 
prolonged use, depending on the type of cooking and the 
regularity of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least 

every four mounths. 
The charcoal filter may NOT be washed or regenerated. 
Remove grease filter. 
Apply a side coal filter and hook in onto the hood. 
Put back the grease filter. 

Replacing lamps 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 

Note:

 The lamps installed can be one of the types described 

in this paragraph. Consult the reference pictures and the text 
below to identify the type of lamp according to the model you 
have. 

Fig. 26 
1.

  Remove the overhead light levering on the fixing clip with 

a screwdriver or similar tool. 

2.

  Replace the damaged light bulb. 

Only use bulbs of 40W max (E14), making sure you do 
not touch them with your hands. 

3.

  Close the overhead light again with the clip. 

Fig. 27 
1.

  Using a flat head screwdriver or equivalent tool, carefully 

pry loose the light cover.   

2.

  Remove the damaged light and replace with a new 12 

Volt, 20 Watt (Maximum) halogen light made for a G-4 
base SUITABLE FOR USE IN OPEN LUMINAIRES.  
Follow package directions and do not touch new light 
with bare hands. 

3.

  Reinstall the light  cover. (it will snap shut). 

If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.