10 TurboLock TL - 500PR
Step 4.
Use a hammer drill and a 15/32” masonry drill bit to drill three holes (0.47 in x 1.97 in deep) into the ground.
Step 5.
Remove the Nuts and Washers from the Sleeve Anchors. Insert the anchors into the holes in the ground and use a
mallet to tap each one a few times to secure them.
Step 6.
Retrieve the Parking Lock and position it so that the ends of the anchors fit through the Mounting Holes. Add the
Washers and Nuts then tighten the Nuts with a wrench.
Step 5
Step 6
Step 4
Step 7.
Open the Battery Box, put 4x D batteries (not included) into the Battery Box and close it. Then use a screwdriver to
reinstall the box into the lock. Be careful not to overtighten this screw; the box should sit flat within the lock.
Step 8.
Making sure the arm is still raised, connect the Battery Box to the lock via its cable.
DO NOT touch the lock’s arm. Once the Battery Box is fully installed, the lock may immediately receive power and turn on
the alarm if the arm is bumped or moved.
Step 9.
Replace the cover and use the keys to lock it in place. Continue to the next section to control the lock.