10 TURBOLOCK TL115
3.2 Main Installation
Step 1.
Start with the outside section. Feed the power cable above the latch and thread
the latch pin through the square hole in latch. The latch pin must be horizontal
while inserting the square hole in latch (Fig. 6).
Do NOT force the cable’s connector end through any part of the lock.
Damaging the connector may make the lock unusable.
It’s highly recommended to leave the door open during installation. And
always keep the bolt extended throughout the installation (Fig. 7)
.
Step 2.
If needed, have someone hold the door itself or hold the outside section flat
against the front of the door. Then take out the inside section, and turn the
thumb vertically before installing (Fig. 8).
Step 3.
Remove the battery compartment cover on the inside section (Fig. 9).
Step 4.
Gently feed the other power cable through the hole of inside section to snap it into
the cable connectors. Then feed the connected power cable into the hole of door
(Fig. 10).
Horizontal
Latch Pin
Fig. 6
Power Cable
Compartment
Cover
Fig. 9
Fig. 10
Extended
Retracted
Fig. 7
Fig. 8
Summary of Contents for TL115
Page 2: ...www turbolock com Customer Service 855 850 8031 ...
Page 33: ......
Page 34: ......
Page 35: ...COPYRIGHT 2019 TURBOLOCK ALL RIGHTS RESERVED ...
