TURBOLOCK TL115 11
Step 5.
Align the mounting holes of inside section with the two round holes near the square hole in latch, then use the two
mounting screws to install the inside section on the door (Fig. 11)
Always keep the bolt extended and the thumb turn vertical throughout throghout the installation (Figs. 7 & 8).
Step 6.
Install the included
9V alkaline
battery or rechargeable battery into battery compartment (Fig. 12).
Make sure the positive and negative pole connection is correct.
Step 7.
Slide down the compartment cover to complete the installation (Fig. 13).
BATTERY
Fig. 11
Fig. 12
Mounting Screws
Fig. 13
Do NOT force the cable’s connector end through any part of the lock. Damaging the connector will make the lock
unusable.
Step 8.
The lock should now be ready to use.
It’s highly recommended to use the default passcode and the app to test
the lock before closing the door
. See Section 6 for information on the default admin passcode. See Section 8 for
information on the app.
Summary of Contents for TL115
Page 2: ...www turbolock com Customer Service 855 850 8031 ...
Page 33: ......
Page 34: ......
Page 35: ...COPYRIGHT 2019 TURBOLOCK ALL RIGHTS RESERVED ...