13
Section 10. Install Instructions
Step 1. Mark Door
Using template,
mark hole on both
sides of door at
required backset,
then mark latch hole
on door edge.
Step 2. Drill Holes
Bore a 2 in. hole on
door face, then drill
1 in. hole in door
edge to intersect
with center of 2 in.
hole.
Step 3. Install Latch
Insert latch into hole and
mark a line around edge
of latch plate and remove
latch. (Fig. 3a)
Chisel approx. 0.1 in.
deep or until latch plate
sits flush with door edge.
(Fig. 3b)
Insert latch then drill 2 x
0.1 in. holes for mounting
screws and fasten latch.
(Fig. 3c)
Note:
Drill 2 in.
hole from both
sides of door to
stop wood
splintering
