8
5.4 Deleting The User Codes
To delete an
individual
user code, follow the instructions below.
1. Enter the master code and press the ‘#’ key.
2. Wait until the beeping sound stops and the blue backlight remains on.
3. Enter ‘0000’ and the sequence number of the code you want to delete and press the ‘*’ key e.g. to
delete the user code starting with one, enter ‘00001’. The lock will emit several beeps to confirm the
selected user code has been erased.
4. If desired, repeat the steps above to delete any other user codes.
If multiple user codes are lost or forgotten or otherwise should be erased, they may be deleted via a
soft or hard reset of the lock. Refer to Section 7.
Section 6. Passage Code Information & Instructions
After the passage code is set, the YL-99 may be set to passage mode by entering the passage
code. In passage mode, all users can press any key to open the door without requiring a code.
6.1 General Passage Code Information
The following information applies to your YL-99’s passage code:
• All codes can be a maximum of 15 digits including the sequence number.
• The sequence numbers for the user codes are ‘1-8’, therefore you must ensure the
each user code is any number from ‘1-8’. The remainder may be any combination of digits from ‘0-9’.
first digit of
