1
------------------------------------------------------------------------------------------------------------------------
ABOUT THIS PRODUCT
Thank you for purchasing your new Turbosmart Race Port. This new Blow off valve (BOV) has great features such as high flow
capabilities: flows more than 100% more air compared to most BOV’s on the market, supports high horsepower applications: ,
quick release V-band clamp for easy mounting, made from lightweight, aircraft grade billet aluminium and has a variety of springs
available to suit different idle vacuum levels.
IMPORTANT NOTES ON YOUR RACE PORT
•
Use only silicone hose that is the correct size and pressure/vacuum rating for your application when fitting your Race Port
•
Ensure that all plumbing is secured with suitable clamps or the correct fittings are used
•
Your Race Port should be mounted at least 100mm from any heat source or adequately shielded
•
This product might not work successfully on MAF/Airflow metered cars, please consult your local performance shop for more
information
•
Check the vacuum level produced by your engine to ensure the right spring is installed in your Race Port for maximum response
RECOMMENDATIONS
•
Turbosmart recommends that your Race Port is fitted and adjusted by an appropriately qualified technician
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR RACE PORT
•
Allow the engine to cool down before installing your Race Port
•
Identify a suitable location along the intercooler/intake piping for the Race Port – this will need to be between the outlet of the turbo
and the throttle body ideally between the throttle body and the intercooler
•
Remove the Race port from the weld on adapter by removing the V-Band clamp. The V-band clamp is removed by rotating the
screw until the end of the screw is flush with the end of the V-Band clamp. Grasp the Race Port and push on the bolt head to open
the V-Band clamp
•
Weld the adapter onto the intake pipe in your ideal position, then allow the adapter to cool down
•
Put the V-Band clamp over the adapter before re-installing the O-Ring seal and the Race Port
•
Open the V-Band clamp and place in position. Tighten the V-Band clamp screw until it is finger tight then turn an additional 3 turns
with an allen key. Be sure not to over tighten the screw as this will cause damage to the V-Band clamp
•
Identify a standalone vacuum / pressure source from a port after the throttle body and connect with correctly sized hose to the
vacuum/boost port on the cap of the Race Port
•
Secure all silicone hose ends with correct clamps
•
Start the engine and check for air leaks in the system
RACE PORT DIAGRAM
Product Name:
RACE PORT
Product Description:
Blow off valve
Product Number:
TS-0204-1001
V-Band clamp
#TS-0204-9503
6.3mm vacuum/boost
nipple
Dash 4 thread
Weld flange
#TS-0204-9501 (SS Weld flange)
#TS-0204-9502 (Alloy weld flange)
M6X10 button head
screws
Top cap
Base
Piston
52X2.5 O-Ring
M5X50 Socket head
screw (4mm allen key)
