SUPRA JZA80 TWIN TURBO BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Turbosmart Pty Limited P.O.Box 264 Croydon, NSW, 2132 Australia ABN: 69 081 069 794
Ph: +(612) 9798 2866 Fx: +(612) 9798 2826 Email: instructions@turbosmart.com.au
PART
NUMBER
FG-ADM-
SUPRA
IMPORTANT NOTES ON FITTING YOUR SUPRA TWIN TURBO ADAPTOR
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
ADAPTOR KIT CONTENTS
Please check that the following items have been supplied in your Supra Twin Turbo Adaptor Kit.
Quantity
Description
Use
1
Supra TT adaptor pipe
Joining pipe from the intercooler to the throttle body
2
90mm constant tension hose clamps
Secures the adaptor pipe to the throttle body
1
70mm constant tension hose clamps
Secures the adaptor pipe to the intercooler pipe
1
75mm ID Silicon hose coupler
To connect the adaptor pipe to the throttle body
1
Pre-assembled Silicon hose assembly
Connects the vacuum/boost source to the Turbosmart BOV
1
5mm spring clamp
Secures the 5mm Silicon hose to the Turbosmart BOV
1
6mm spring clamp
Secures the 6mm Silicon hose to the factory vacuum/boost source
2
19mm blanking plug
To block off the factory boost pipe and return pipe
1
250mm long cable tie
To support the radiator hose by securing it to the BOV
2
150mm long cable tie
To support the vacuum/boost hose by securing it to radiator hose
Note:
The Supra TT pipework adaptor kit readily accepts the following Turbosmart BOVs:
Blow Off Valve Name
Part No.
Blow-off Valve - Vee Port
FG-BOV-002VP
Blow-off Valve - Supersonic
FG-BOV-003SS
Blow-off Valve - Megasonic
FG-BOV-003MS
To install a Dual Port or Plumb Back BOV, fabrication will be required to connect the plumb-back fitting to the intake.
FITTING YOUR SUPRA TWIN TURBO BOV ADAPTOR
Note:
Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.
Step 1.
Locate the factory BOV and factory intercooler
outlet pipe.
Step 2.
The intercooler inlet pipe needs to be removed
to access the factory BOV. Loosen the two hose
clamps securing the intercooler inlet pipe with a Philips
head screwdriver or 10mm socket.
Factory BOV
Factory Intercooler Outlet Pipe
Factory Intercooler Inlet Pipe
