www.TURBOSMART
ONLINE
.com
1
------------------------------------------------------------------------------------------------------------------------
IMPORTANT NOTES:
Please thoroughly read and understand these instructions before commencing this installation.
Ensure that the car and exhaust system are cold before commencement of installation.
RECOMMENDATIONS
Turbosmart recommends that your gauge is fitted and adjusted by an appropriately qualified technician
Gauge mount cup (TS-0101-2024) Sold separately
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR EXHAUST GAS TEMPERATURE GAUGE
Exhaust Gas Temperature Sensor
The exhaust gas temperature (EGT) gauge requires a reliable temperature signal from the exhaust system to provide an
appropriate EGT indication.
After deciding the location of the sensor, drill an 8.70 mm diameter hole. Use a 1/8 NPT tap to thread the hole for the included
NPT fitting.
First secure the 1/8 NPT fitting by hand, and then turn 1.5 revolutions by a socket/spanner. Torque to 3 Nm (2.2 ft.lbf)
After the 1/8 NPT fitting is securely fastened, insert the bush, nut and thermocouple in series as shown in figure below.
The thermocouple depth is to be set at approximately half the diameter of the exhaust pipe.
Secure the sensor assembly by tightening the securing nut. Torque to 6Nm (4.4 ft.lbf)
Be sure not to over tighten the EGT sensor as it may cause sensor failure or thread damage.
Route the sensor cable to the gauge. Ensure cable is kept away from heat as much as possible.
Product Name:
Electrical EGT Gauge
Product Description:
EGT Electrical Gauge 400 to 2200 DEG F
Product Number:
TS-0701-2011
