16
17
Check that the safety screw (14) that blocks the
bonnet is properly fixed.
• Inspection plugs
Make sure that the inspection plugs (34) on the ma-
chine are tightly closed.
Make sure to use the proper key supplied
w i t h
the machine (35) in order to
close the ring nuts tightly.
Version with mixer (MF version)
• Grill on mixer
Check that the grill on the mixer
is properly positioned.
While lifting the grill on the mixer, the machine stops
automatically. This is due to a device that switches off
the diesel engine.
In order to start the ma-
chine again set back the
grill in the right position
and start again the en-
gine.
• Control lever
Stop the motion of the
mixer using the indicated
control lever (36).
After eventual repair or
maintenance works make
sure that all the safety
devices are mounted
back and that no tool
is left inside the engine
compartment or the material hopper.
14
Tools or wipers left in the engine compartment may as
well cause the brake down of the cooling fan.
Before starting the machine,
prepare the desired mix in
a site or built-in mixer and
separately prepare 15 ÷ 20
liters of slurry (50% water
+ 50% cement or hydrated
lime) and pour it into the
hopper.
Before starting the machine make sure that no one
apart from the authorized personnel is standing
close to it.
Use gloves in nitrile for protection against cuts and
abrasions, preferably models with CE 940072 certificate
and googles that can provide a total protection to
the eyes, with infrangible and anti-fogging lenses (in
policarbonate, and vinyl chloride).
Starting up
Check that the air delivery cock (37) is open, that the
discharge cock (38) is closed and that the air cock to the
gun (15) is open.
34
35
36
Summary of Contents for UNI 30 D
Page 4: ...4 ...