Turbosound NuQ102-AN, Quick Start Manual

16

NuQ-AN series

Quick Start Guide

17

Suspending with Eyebolts

NuQ-AN cabinets can be suspended using optional eyebolts coupled to the internal rigging points provided 

on the top, bottom and sides and back. The simplest method is to use the two rigging points on the top and 

a single pull-back rigging point in the centre of the rear panel.

Remove the appropriate countersunk screws and replace them withshoulder eyebolts, which must have 

a thread length of at least 18 mm. Use the rear rigging point to angle the cabinet for optimum room 

coverage. Cabinets may be hung upside down if required.

IMPORTANT NOTE FOR ALL INSTALLATION METHODS:

 The mounting of a permanently installed sound system 

may be dangerous unless undertaken by qualifi ed personnel with the required experience and certifi cation 

to perform the necessary tasks. Walls, fl oors or ceilings must be capable of safely and securely supporting 

the actual load. The mounting accessory used must be safely and securely fi xed both to the loudspeaker 

and to the wall, fl oor or ceiling.

When mounting rigging components on walls, fl oors or ceilings, ensure that all fi xings and fasteners 

used are of an appropriate size and load rating. Wall and ceiling claddings, and the construction and 

composition of walls and ceilings, all need to be taken into account when determining whether a 

particular fi xing arrangement can be safely employed for a particular load. Cavity plugs or other specialist 

fi xings, if required, must be of an appropriate type, and must be fi tted and used in accordance with the 

maker’s instructions.

The operation of your speaker cabinet as part of a fl own system, if installed incorrectly and improperly, 

can potentially expose persons to serious health risks and even death. In addition, please ensure that 

electrical, mechanical and acoustic considerations are discussed with qualifi ed and certifi ed (by local state 

or national authorities) personnel prior to any installation or fl ying.

Make sure that speaker cabinets are set up and fl own by qualifi ed and certifi ed personnel only, 

using dedicated equipment and original parts and components delivered with the unit. If any parts or 

components are missing please contact your Dealer before attempting to set up the system.

Be sure to observe the local, state and other safety regulations applicable in your country. MUSIC Group, 

including the MUSIC Group companies listed on the enclosed “Service Information Sheet”, assumes no 

liability for any damage or personal injury resulting from improper use, installation or operation of the 

product. Regular checks must be conducted by qualifi ed personnel to ensure that the system remains in a 

secure and stable condition. Make sure that, where the speaker is fl own, the area underneath the speaker is 

free of human traffi c. Do not fl y the speaker in areas that can be entered or used by members of the public.

Speakers create a magnetic fi eld, even if not in operation. Therefore, please keep all materials that can 

be affected by such fi elds (discs, computers, monitors, etc) at a safe distance. A safe distance is usually 

between 1 and 2 metres.