TROUBLE SHOOTING GUIDE
1.
Verify that all the bolts and nuts are locked properly and the turning parts should be
turned freely without damaged parts.
2.
Clean the equipment with soap and slightly damp cloth only. Please do not use any
solvent to clean the equipment.
Problem
Potential Cause
Corrections
Base is unstable.
1.
Floor is not flat or there is
small object under the front
or rear stabilizer.
2.
The rear stabilizer end caps
have not been leveled
when adjusting.
1.
Remove the object.
2.
Adjust the rear stabilizer end caps.
Handlebar is
shaking.
The Bolts are loose.
Tighten the Bolts.
Loud noise from
the moving parts.
The interval of the parts is
improper tighten.
Open the covers to adjust.
No resistance
when riding the
bike.
1.
The interval of the magnetic
resistance increases.
2.
Tension control knob is
damaged.
3.
Belt slips.
4.
The bearing set is damaged.
1.
Open the covers to adjust.
2.
Change the tension control knob.
3.
Open the covers to adjust.
4.
Change the bearing set.
