19
2018/09
9
Special Instruction for Use
■
Install the HMI device according to the accompanying installation instructions.
■
Ground the HMI device according to the accompanying installation instructions.
■
Only qualified personnel may install the HMI device or repair it.
■
Ensure that the aeration holes are not covered.
■
Care shall be taken not to allow layers of dust to form on the faceplate of the HMI device in
a way that might cause the accumulation of static charges. Keep the faceplate of the HMI
device clean:
The equipment must be cleaned only with a soft cloth and neutral soap product.
■
Do not use solvents.
■
This device should not be used for purposes and methods other than indicated in this docu-
ment and in the documentation accompanying the product.
10 Getting Started
10.1 Programming with CODESYS
The devices are delivered with a pre-installed CODESYS runtime.
CODESYS (≥ V 3.5.12.0) and the package “TXxxx HMI/PLC series” for the HMI/PLCs have to be
installed on a PC computer running Microsoft Windows.
The CODESYS software as well as the CODESYS package for the HMI/PLCs can be downloaded
from
www.turck.com
.
10.2 Programming with TX VisuPro
For programming the HMI/PLCs with TX VisuPro, the software tool has to be installed on a PC
computer running Microsoft Windows.
If TX VisuPro should be used instead of the CODESYS TargetVisu, the TX VisuPro runtime needs
to be installed. Before installing TX VisuPro, the existing TargetVisu runtime has to be deleted. To
do so, use the internal configuration menu:
“System Settings”
→
“Management”
→
“Data”
→
“Clear”
There are two options to transfer a TX VisuPro runtime project to a device:
■
Ethernet:
Connect the HMI device to the computer with an Ethernet network. In TX VisuPro select the
command Run/Download to target. You may have to ensure that the proper firewall policy
has been configured in the computer to allow TX VisuPro to access the network.
■
USB:
Create an Update Package using TX VisuPro and copy it to a USB Flash drive.
