Operation
The machine will move faster the farther the
motion control lever is moved from the neutral
position.
4.
To stop, position both motion control levers
in the neutral position; releasing the lever will
automatically return it to neutral.
Note:
Stopping distance may vary depending on
the spreader-sprayer load.
Driving in Reverse
1.
Move the motion control lever to the neutral
position.
2.
To move rearward in a straight line, slowly move
both levers rearward with equal pressure.
g016673
Figure 18
To turn left or right, release pressure on the
motion control lever toward the desired turn
direction.
3.
To stop, position both motion control levers in
the neutral operate position.
Note:
Stopping distance may vary depending on
the spreader-sprayer load.
Adjusting the Front Reference/Speed
Control Bar
Adjust the front reference/speed control bar for
desired maximum forward speed.
1.
Stop the machine and move the motion control
levers to the neutral position.
2.
Loosen the knobs on both sides of the control
tower.
g314122
Figure 19
1.
Motion control levers
2.
Adjustment knob
3.
Move the bar forward to obtain the fastest speed.
Move the bar backward to obtain the slowest
speed.
4.
On both sides, tighten the knobs.
Important:
Make sure the knobs are tight so the
front reference/speed control bar does not move
during operation.
Stopping the Engine
1.
Move the motion control levers back to the
neutral position and bring the machine to a full
stop.
2.
Engage the parking brake.
3.
Place the throttle midway between the “SLOW”
and “FAST” positions.
4.
Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the
“OFF” position to stop the engine.
5.
Remove the key to prevent children or other
unauthorized persons from starting the engine.
Operating the Sprayer
The sprayer disperses liquid substances. Before using
the sprayer make sure it has been properly cleaned
before adding any chemicals. When using the sprayer,
first fill the spray tank, then apply the solution to the
work area, and finally clean the tank. It is important
to complete all three of these steps to avoid damaging
the sprayer. For example, Do Not mix and add
27
