Maintenance
g268088
Figure 41
4.
Insert BLACK test lead in COM receptacle in
meter. Connect to BLACK post terminal on
shunt (3).
5.
Rotate selector to 300 mV position.
6.
With the engine running at 3600 RPM, the output
should be 3-20 Amps.
Note:
Depending on battery voltage and/or current
draw on system
If NO or LOW output is found, be sure that
regulator-rectifier is grounded properly and all
equipment connections are clean and secure. If
there is still NO or LOW output, replace the
regulator-rectifier.
Adjustments
Note:
Shut off engine, wait for all moving parts to
stop, engage parking brake, and remove key before
servicing, cleaning, or making any adjustments to the
machine.
Pump Drive Belt Tension
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Adjust tension by loosening or tightening the eye
bolt nut. To increase the tension tighten the nut.
To decrease the tension, loosen the nut.
g314335
Figure 42
1.
Eye bolt nut
Adjusting the Parking Brake
If the parking brake does not hold securely, an
adjustment is required.
1.
Park the machine on a level surface.
2.
Shut off engine and wait for all moving parts to
stop.
3.
Check the air pressure in the drive tires. If needed,
adjust to the recommended inflation; refer to
Check Tire Pressure
section.
4.
Disengage the park brake.
5.
Loosen the two jam nuts on the brake linkage on
the left side of the unit.
6.
To increase the brake force, turn the linkage
counterclockwise 1–2 turns.
53
