13
85872 RevA
TURFCO T3000 APPLICATOR
15° MAXIMUM
15° MAXIMUM
OP85872-05
FIGURE 7
15° MAXIMUM
15° MAXIMUM
Operation on Slopes, Inclines or Hills
(See Figure 7)
For safety reasons, the best way to drive up or down a slope is at a 45º degree angle to the slope. This will
keep you from being directly above or under the mass of the machine. This machine is only rated to go on
slopes of 15º degrees or less. Slopes of more than 15º degrees could cause injury to the operator or damage
to the machine.
Roll overs can occur
, using the machine to traverse along a slope of more than 15º degrees
is not recommended. You should always use walking applicators on slopes more than 15º degrees.
● Do not turn the machine while on a slope or incline.
● If one must operate across a slope, angle the machine 45º degrees to the direction of the incline no matter
if you are going up or down the slope.
● Do not operate the machine across the face of a slope or at 90º degree angles to the slope.
The Turfco T3000 Applicator is
not designed
to be operated
on any incline or slope exceeding 15º Degrees.
Operation on inclines of more than 15º degrees can result in
injury and/or damage to the machine.
Operation on inclines exceeding the 15º degree limit can cause spillage of materials
WARNING
OPERATION
