Lit. No. 75371, Rev. 01
12
October 1, 2018
WIRING INSTRUCTIONS
1. Mount the rear plug bracket on the back of the
vehicle. Locate the harness toward the center of
the bumper as it will reduce the amount of debris
getting onto the plug. Apply dielectric grease to
the plug.
2. Route the wires from the back to front using
zip-ties or clamps (not supplied). Do not secure to
brake lines, fuel lines, or near exhaust, engine, or
moving parts. Use the heavy-duty zip-ties along
the frame and lighter duty zip-ties everywhere else.
3. Drill a 3/4" hole in the
¿
re wall near the steering
column. Be sure to check for wires and
components in the way (both sides of the
¿
re wall)
before drilling the hole.
CONTROL AND HARNESS DIAGRAM – MODEL TS-300-EG-1
4. Run the data cable into the cab. Zip-tie the wire
under the dash so that it does not get in the way of
the brake or accelerator pedal. Leave enough of the
data cable outside of the dash so that the operator
can hold the control pendant in hand. Install the
pendant mounting base and bracket. Stick the
hook/loop fastener to the pendant and pendant
base.
5. Connect the harness to the back of the control.
Zip-tie loose control harness and move to the
engine compartment. Do not mount close to any
heater vents.
6. Connect power leads to the battery:
Red: POSITIVE (+)
Black: NEGATIVE (–)
Always connect to the primary battery if using
a dual battery system. Secure loose loom to
any other large or medium vehicle harness with
medium duty zip-ties to secure the wiring harness.
7. Push the ON/OFF button on the control to check
for power. When con
¿
rmed, turn power OFF. The
electrical portion of the installation is complete.
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
CAUTION
Do not alter, modify, or install additional
components in shaded areas shown below.
Failure to comply may interfere with airbag
deployment or cause injury to operator in an
accident.
Summary of Contents for TS-300-1
Page 2: ......
