Sweeping / Powerbrooming:
•
For comfortable work with the sweeper, it is best to start working
at the location closest to the power source and to proceed away
from the power source.
•
Sweep the lawn at a right angle from the power source and place
the power cord on the side that has already been swept.
ATTENTION!
Do not place too much strain on the motor when
working, especially in demanding conditions. When the motor is put
under strain, the motor speed will decline and you will hear a
change in the noise of the motor. Whenever this happens, stop
working, release the starting lever, and reduce the brush depth.
Otherwise, the machine could be damaged.
NOTE:
The motor is protected by a safety mechanism that is
activated at the instant that the brush is caught or the engine is
overloaded. Whenever this occurs, turn the machine off and pull the
power plug out of the power source. The safety mechanism will
reset only when the starting lever is released. Remove all
obstructions and wait several minutes before resetting the safety
mechanism and resuming work. At this point, do not play with the
starting lever as this will extend the safety mechanism reset time. In
the event that the machine turns off again, raise the height of brush
depth again, which in turn will reduce the load on the motor further.
Page No. 13
www.turfmatic.info
