WARNING: THE Turin Tampa Shower Kit is designed to be used with tile walls.
If you are using a pre-made Acrylic/ABS/FRP shower stall that will be thicker
than average wall board plus tile then you must consider the offset of the
pre-made panel. The shower tray has 1/4" of tolerance for over sized wall thickness.
The shower tray needs to sit on a flat level base for proper support. Ensure that the
area for the shower tray is properly prepared for installation.
Using the drawing provided, place the floor drain in the proper location so that
the shower tray drain and the floor drain are in line after final installation.
Place the shower tray in the final installation position line up the drain holes
and check for level. If not level make adjustments to the floor at this time.
