8
Refueling volume depends
on the actual situation
The amount of refueling
depends on how much oil
is contained in the oil
chamber. More oil is
needed and more oil needs
to be discharged, and less
oil needs less oil.
So drain the oil completely
or check the oil indicator
port after filling the oil
1.3.6 Operation notes
The robot system is complex and dangerous. During the re-practice, you must pay
attention to the safety of any operation on the robot. Whenever you enter the working area
of the robot, it may cause serious injury, and only trained and certified personnel can enter
the area.
The following safety rules must be followed:
●
In case of fire, use a carbon dioxide fire extinguisher.
●
The emergency stop switch is not allowed to be short-circuited.
●
When the robot is in automatic mode, no one is allowed to enter its area of
motion.
●
In any case, do not use the original boot disk of the robot, use a copy disk.
●
When the robot is stopped, nothing should be placed on the fixture, and it must be
empty.
●
In the event of an accident or abnormal operation of the robot, you can use the
emergency stop button to stop the operation.
●
Because the robot is in the automatic state, even if the running speed is very low,
its momentum is still very large, so when programming, testing and maintenance work, the
robot must be placed in manual mode.
●
The pressure in the gas circuit system can reach 0,6MP, and any relevant
maintenance must cut off the gas source.
●
Commission the robot in manual mode. If you do not need to move the robot, you
must release the enabler in time.
●
When the debugger enters the robot working area, he must carry the teach pendant
with him to prevent misuse by others.
●
When you receive a power outage notification, turn off the robot's main power
supply and air supply in advance.
●
After a sudden power outage, turn off the main power switch of the robot in
advance before calling, and remove the workpiece on the fixture in time.
●
Maintenance personnel must keep the robot keys well, and it is strictly forbidden
for unauthorized personnel to enter the robot software system in manual mode, and read or
modify the programs and parameters at will.
