background image

LIMITED LIFETIME WARRANTY

To obtain service, please contact  Service Department:

1-800-887-6326, 9AM-5PM Central Standard Time.

Model No.: #

 355-3000, 355-3001, 355-3002, 355-3003

Turn of the Century

 ceiling fan is warranted, for the limited lifetime warranty of the original retail 

purchaser for residential use, against defects in material and workmanship for the fan motor. If the 
original purchaser cease to own the fan, this warranty and any implied warranty become void.

If your Fan motor fails to operate, we will repair the defects for the motor at no charge or at our 
option replace the ceiling fan with a comparable model. All costs of removal and re-installation are 
the expressed responsibility of the purchaser.

Any replacement of defective parts for the ceiling fan must be reported within the first 30 days of 
purchase.

Due to varying weather conditions, this warranty does not cover changes in plated finishes.
Any glass provided with this fan is not covered by the warranty.

This warranty excludes defects, malfunctions, or failures of any 

Turn of the Century

 Fan that are 

caused by repairs by persons not authorized by us, use of parts or accessories not authorized by us, 
mishandling, improper installation, modifications or damage to the Fan while in your possession, or 
unreasonable use, including failure to provide necessary maintenance.

To obtain service, contact 

Turn of the Century

 Service Department at 1-800-887-6326, 9AM-5PM 

CST. 
You will be responsible for all insurance and freight or other transportation charges to our factory or 
service center.  A copy of sales receipt is required in order to obtain service. Your Fan should be 
properly packed to avoid damage in transit, for we will not be responsible for any such damages.

In no event shall 

Turn of the Century

 Fan be liable for consequential or incidental damages.

Some states do not allow the exclusion or limitation of consequential or incidental damages, in which 
case the above limitation or exclusion may not apply. 

This warranty gives you specific legal rights and you may also have other rights which vary from state 
to state.

Turn of the Century

TM

Turn of the Century

Summary of Contents for 355-3000






Reviews: