1. Tuck connections neatly into ceiling outlet box.
2. Slide the canopy up to mounting bracket and place the key
hole on the canopy over the screw on the mounting bracket,
turn canopy until it locks in place at the narrow section of the
key holes. (Fig. 10)
3. Unscrew the screws and washers from the bottom of motor.
Align the circular hole on canopy with the remaining hole on
the mounting bracket, secure by tightening the two set screws.
Note:
Adjust the canopy screws as necessary until the canopy
and canopy cover are snug.
1. Attach blades to blade arms using three screws and fiber
washers (Fig. 11). Start a screw into the blade arm, do not
tighten. Repeat for the 2 remaining screws and washers.
2. Tighten each screw securely starting with the center screw.
Make sure the blade is straight. Repeat steps for the remaining
blades.
3. Fasten the assembled blades to the motor by lining up the slots
of the blade arms with the tabs on the motor, then tighten the
two screws and washers already installed in the blade arms
(Fig. 11).
4. Repeat procedure with remaining blade arms.
Finishing the Fan Installation
Attaching the Fan Blades
Figure 10
Figure 11
Warning: Make sure the tab on the hanging bracket
properly sits in the groove in the hanger ball before
attaching the canopy to the bracket by turning the
housing until it drops into place.
!
Warning: To reduce the risk of personal injury, do not
bend the blade arms while installing, balancing the
blades, or cleaning the fan. Do no insert foreign objects
between rotating fan blades.
!
Outlet Box
Mounting
Bracket
Screw
Screw
Canopy
Canopy
Bottom Cover
Motor
Screws
Screws
Fiber
Washers
Blade
Blade Arm
7
