Blinking Green and Blinking Red will only occur if
the Receiver is configured to indicate a correct or
incorrect answer (CORRECT POLLING mode).
Setup Modes:
Active at any time the keyboard is ready for input.
Match Mode
(Check RF connection)
Press ‘?’
In order for Match Mode to operate properly
an RF Receiver MUST also be placed into
Match Mode.
Quick YELLOW Blink then OFF
-
Receiver is not accepting data at this time
BLINKING YELLOW
- key is
being transmitted
SOLID GREEN
- RF
receiver found, but not in Match Mode
SOLID RED
- Key
transmit failed
BLINKING GREEN
-
RF
receiver in Match Mode found
BLINKING RED
- RF
receiver found, but not in Match Mode
Auto Match Mode
(find RF Receiver)
Press Go/Login, while holding Go/Login,
quickly press and hold ‘?’. Release both
keys.
In order for Auto Match Mode to operate
properly an RF Receiver MUST also be
placed into Match Mode, otherwise the
keypad will always indicate that Auto Match
Mode has failed.
BLINKING YELLOW
-
search is in progress
SOLID GREEN
-
search successful – Match Mode exits
SOLID RED
-
search failed – Match Mode exits
Set RF Channel
Press GO/LOGIN
Set RF Channel mode is indicated by the
status LED flashing a RED then GREEN
pattern. Set RF Channel mode exits
automatically after three valid keys are
pressed, if no valid key is pressed for 5
seconds, or at any time an invalid key is
