Speed Gate Turnstile User Manual
When the gate
does not
open in desired position, You can adjust the channel
position by enter the parameter setting according to the voice prompt to
manually move the pendulum door toward the right direction to the desired
position, press ok to save
< D-4 >
Open speed setting
Set open speed, value from 1-10, 1 is the fastest speed, 10 is slowest speed.
< D-5 >
Gate type
Set type
；
swing gate / flap gate, ( 0: swing gate, 1: flap gate). This parameter is set
as factory default. Do not change
< D-6 >
The clutch
According to the corresponding drive Settings of brake configuration, "0 is no
clutch, 1: clutch" this parameter is set according to the factory default. Do not
change.
< D-7 >
Resistance rebound Mode
When a pedestrian pass the channel, and hit by the gate, it will bounce back or
keep closing, default setting is 0.
0: Hit the pedestrian then bounce back then keep open1: hit the pedestrian, stop for
seconds, and then keep open
< D-8 >
Counter strength (master)
When the swinging door is in the closed non-working state, the reverse force can
be adjusted when the swinging door is forced open by the external force. The
larger the value, the greater the force ( value 1-20), default
：
14
< D-9 >
Reset time
Setting the time interval between swiping card
《
value 0.1- 10
》
default
：
0.1
< D-10 >
Buffer strength from gate closing (master)
The buffer strength is adjusted, the larger the value, the faster the closing speed
www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099
