[8]
SIO - The Secondary I/O Board is located in every pedestal except the first pedestal of
the suite. This board receives incoming power and Data from the PIO. It also powers the
transmitter sensors, the secondary LSI, and the secondary motor and chopper board.
C: Lane Status Indicator (LSI) and Reader Mounting
The LSI is the indicator mounted on the top ends of each lane. It indicates the lane
status as shown below.
Present Card
Proceed Through Lane Do Not Pass/ Lane in Alarm
The LSI / Reader Mount bracket is designed to accept a single-gang switch-plate size
proximity card reader. The card reader may be mounted at Orion’s manufacturing facility
during the production process or may be installed in the field at a later date. If a non-
standard proximity card reader is used
.
5.
WIRING
A: Single Lane
- One OBSG-HG-CV speedgate consists of two pedestals.
Each
lane will contain one (1) Primary I/O Board (PIO) and one (1) Secondary I/O Board
(SIO), one (1) Primary motor, and one (1) secondary motor. An 18awg/4 conductor
interconnect cable is required for power and communication to the SIO board from the
PIO board. The motors will be connected via a supplied cable coiled in the primary
pedestal. Each lane’s PIO will require an isolated fire alarm relay and an isolated 18/2 or
16/2 24v power line from the power supply. The PIO will also receive communications to
the remote lane controller (RLC) via either an Ethernet cable, or 18awg/4 conductor
cable for serial communications. All pedestals must be grounded.
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099
