Copyright © 2022 ves-artex.com| All Rights Reserved
V01-December 2020
55” BELT DRIVE
ECV
STORM FAN
| Installation Manual
pg. 4
4.
Install the two side panels to the main housing
assembly, one per each side.
Use the screws and washers provided; 4 per
side.
The side panels will fit on the inside of the fan
housing.
NOTE
the side panels will fit inside the main
housing, line up the 5 pre drilled holes
Number
Description
1
Screw M6 x 25
2
Washer
3
Nut
5.
Install the louver assemblies onto the side
plates.
Starting at the back of the fan, hold the first
louver in place with the pointed end of the
louver facing down toward the ground
Place each bolt through the bottom hole of
the bracket and into the middle of the louver.
Only hand tighten
Place second bolt into curved slot and line up
with second hole in louver
NOTE
: the louvers will face the narrow end of
the side plate
6.
Repeat for all louvers
Narrow End of the Louver
