STEP 5
TUT POWER BAR
™
ASSEMBLY
1. If you purchased a Power Bar, slide the Power Bar (fig 5) over
the cable (fig 9) and ensure that the cable is travelling freely
between the two Power Bar tabs
2. Make sure the Power Bar tabs fit to the outside of the Anchor
Post (fig 6)
3. Insert shoulder bolt (fig 7) and nut (fig 8). Make sure the
Carabiner Loop on the Power Bar is on the underside facing to the
floor.
4. With a Carabiner, connect the Ball and Carabiner Clasp to the
Power Bar Carabiner Loop
fig 9
fig 8
fig 7
fig 6
fig 7
fig 8
fig 5
Please refer to Installation Instructions Video
Anchor Post
Power Bar tabs
Carabiner Loop
