Initial Configuration
TUT Systems, Inc
Page 20 of 104
P/N
220-06288-20
11. Click
OK
.
12. Set the following parameters in the
Settings
tab:
•
Select
Terminal keys
.
•
From the
Emulation pull-down
menu, select
Auto Detect
.
•
Set
Backscroll buffer lines
to
500
.
13. Click
OK
to close the dialog box.
Note:
To avoid cutting off a section of the display, set the window to full screen
size.
14. To save this configuration for the future, select
File/Save As
and enter the name of
the file for this configuration.
Perform the following steps to log on to the SMS2000:
1. Power up the SMS2000 when the system is finished rebooting (1 to 5 minutes). You
will hear three consecutive beeps when ready.
2. From
the
Hyperterm Call
menu, select
Connect
.
3. To verify that you have correctly configured your console port, press
<Enter>
.
•
If the Login Display screen does not appear:
•
Make sure that you entered the correct settings.
•
Verify that you are using the correct cable and that the cable is not
damaged.
•
Check that you have good cable connections and connector.
If you are still unable to view the Login Display screen, call your Tut Systems
Customer Service representative.
4. Log on using the username “manager” and the password “manager.”
Note:
The password “manager” is the factory default password for the
SMS2000. You are strongly encouraged to change your initial logon password
as soon as possible to ensure security. For instructions on changing your
password, see the
Changing Your Password
section of this chapter
.
Warning
Security is a critical component of this system. As the system administrator, it
is
your
responsibility to manage the security of this system.
Establishing a Connection Via Telnet
Perform the following steps to gain Telnet access to an unconfigured SMS2000 from the
subscriber port:
To connect directly to the subscriber port:
