TUTA-B12 GSM REMOTE CAMERA USER MANUAL
19
confirmation SMS.
4. The user then needs to make the sensor work and transmit signal to be captured by
the TUTA camera.
5. When the TUTA camera receives the sensor signal, it will emit a BEEP tone and send
a notification message SMS: Sensor *** successfully paired.
6. To exit the loading mode manually, press the
SET
button of the camera, TUTA camera
will emit a Beep… tone and exit the loading mode.
3.9.2 Removing a sensor from camera
The
Master
or
family
user sends following SMS message to the TUTA camera:
Remove a sensor:
#112#
SensorDescription
#...#
SensorDescription
#
(22)
Remove all sensors:
#112#
(23)
Sensor description
should be the existing sensor which the user wants to remove.
3.10 Resetting the camera
User can reset the camera to factory settings if the user forgets the master number or
camera does not work normally.
After resetting to the factory setting, the camera will delete all set numbers and other set
values and the user will need to setup the master number from the beginning.
Method 1: Reset via the camera
Switch the TUTA camera off. It must remain off for a minimum of 20 seconds.
Press and hold the
SET
button and then switch the TUTA camera back on.
The indicator light will be green for 2-4 seconds after which it will flash red.
If resetting of TUTA camera is successful, a BEEP tone will be emitted.
Method 2: Reset via SMS command
The
Master
user sends following SMS message to TUTA camera:
Reset the camera:
#08#
password
#
(24)
