TUTA-B12 GSM REMOTE CAMERA USER MANUAL
20
Chapter 4
Advanced settings
4.1 Remote control
4.1.1 Pairing a remote control
Normally the remote control will be paired in factory. if the remote camera can not work
with TUTA camera, user should pair the remote control separately. A camera can pair up to
5 remote controls.
Operations
Status
Camera indicator
1. Press and hold the
Set
key
for 2 seconds
Indicator light turns to
orange (Learning mode)
Green, flashing or
constantly light.
2. Press any button on the
remote control (with battery
inside) to send a signal to TUTA
camera.
TUTA camera will emit a
BEEP tone and indicator
will turn green for 2S.
(Added successfully.)
Orange, flashing
3. Repeat step2 to load another
new remote camera.
Orange, flashing
4. Press the
Set
key to exit the
learning mode or waiting for 15
seconds to auto-exit.
Indicator light turns green,
flashing
or
constantly
light. (Exit learning mode)
Orange, flashing
4.1.2 Remote control instruction
There are three buttons on the remote control:
A. Arm the TUTA camera
When is pressed, the indicator light on the TUTA camera will turn green. This
indicates that the TUTA camera is in armed mode.
B. Disarm the TUTA camera
When is pressed, the indicator light on the TUTA camera will slowly flash green.
This indicates that the TUTA camera is in disarmed mode.
C. Emergency button
When is pressed, the indicator light on the TUTA camera will rapidly flash
green. Then the TUTA camera will dial the mast
er user’s number. A live audio stream
