16
17
www.tuttibambini.com
www.tuttibambini.com
Removing the ISOFix base
Correct Shoulder Height
1. Before the car seat is installed
in the vehicle
The harness has 2 positions. The straps should go in
to the slots at, or nearest slots above the height of the
childs shoulders. To adjust the harness, remove each
strap by passing it through the slots from the front
to the back of the seat; re-route the straps through
the appropriate slots. If the shoulder height is not ok,
please re-install the seat again.
2. Checklist to ensure that your baby is
in the car seat correctly
a) The straps of the child safety seat are close to the
body without constricting the child.
b) The shoulder straps are adjusted correctly.
c) The straps are not twisted..
d) The tongue from the adult seat is engaged
correctly from the vehicle.
1. Removing the ISOFix car restraint
Ensure the car seat carry handle is in the
upright position, Pull the red lever on the front of the
ISOFix base upwards towards the baby car seat
to remove the child car seat from the isofix
base.
2. Folding away the ISOFix sytem
Pull the black plastic coat of the ISOFix connectors
to make the isofix connectors in the window red. Now
release the car seat from the ISOFix base and the
ISOFix connectors.
Press the red button on the support leg to shorten
the length.
TOO LOW
3
7
7
TOO HIGH
CORRECT
Unlocked
Locked
