10 Multiformat 3D Monitor
3. Controls & Functions
• [SCAN] Button/Lamp
- Used to change the scan mode. Press the
button to activate through the scan modes:
OVER SCAN -> ZERO SCAN -> UNDER SCAN ->
2:1 SCAN -> 1:1 SCAN -> FIT WIDTH
* See section “Other Functions [1]SCAN Mode”
for more information.
• [MARKER] Button/Lamp
- Used to activate/deactivate the marker.
- The desired aspect ratio can be displayed on
the screen properly when the type of marker
selected from the main menu.
- If AFD is selected on the main menu, marker
automatically activates when input signal
contains the embedded AFD data.
• [APERTURE] Knob (TDM-243W)
- Used to adjust the picture sharpness.
- The value is selectable between 0 ~ 25.
• [BRIGHT] knob (TDM-243W)
- Used to adjust the degree of brightness.
- The value is selectable between -100 ~ 100.
• [CONTRAST] knob (TDM-243W)
- Used to adjust the contrast.
- The value is selectable between -100 ~ 100.
• [MENU] Button
- Used to activate/ deactivate the main OSD Menu.
• [DOWN]/[UP] Button
- Used to select Main menu and submenu.
- Used to increase/decrease the value of
selected feature.
• [ENTER] Button
- Used to enter submenu and see the feature
selected.
- If the source image is larger than the resolution
of the screen in 1:1 SCAN Mode, press this
button to move the position of the image.
*See section “Other Functions[1]SCAN Mode”
for more information.
• [OPERATE] Lamp
- Indicates condition and power status of unit.
- Light turns off when the power is disconnected.
- Standby mode is indicated by a red LED light.
- Normal (active) mode is indicated by a Green
LED light.
- Restores to previous state when monitor
power turns off and comes back on.
• [POWER] Button
- Used to turn power on and off.
• [TALLY] Lamp
- Tally lamp that can be toggled in green or red
using the REMOTE(RJ-45) port.
Summary of Contents for TDM-243W
