Multiformat 3D Monitor 29
• This product supports various scan modes.
• Press [SCAN] button on the front of the monitor to activate different scan modes.
1. [Press [SCAN] button continuously to activate various scan modes:
OVER SCAN -> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> FIT WIDTH
2. Scan mode types are differed by connected signal.
- SDI : OVER SCAN -> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN -> FIT WIDTH
- HDMI : OVER SCAN -> ZERO SCAN -> UNDER SCAN -> 2:1 SCAN -> 1:1 SCAN
3. The following represents the different types of scan mode. When a scan mode is selected, display
skips the next mode if its required condition is not met.
- OVER SCAN : Zooms in/out of the image to 96% of its original size without changing the aspect
ratio of.
- ZERO SCAN : Zooms in/out of the image without changing the aspect ratio.
- UNDER SCAN : Zooms in/out of the image without changing the aspect ratio. Also, displays the
data at the top of the horizontal blanking block.
- 2:1 SCAN : Magnifies the original image two times. This feature is available only when the size of
the original image is ½ size or smaller than the screen size.
- 1:1 SCAN : 1:1 pixel mapping of original image. This feature is available only when the size of the
original image is bigger than the screen size. Press [ENTER] button to rotate the position.
MID LEFT -> TOP LEFT -> TOP MID -> TOP RIGHT -> MID RIGHT -> BOT RIGHT -> BOT MID -> BOT LEFT
- FIT WIDTH : In SD mode, zooms in to fit width of the original image to the width of the screen
without changing the aspect ratio.
[1] SCAN MODE
6. Other functions
<Position change in 1:1 SCAN>
<MID CENTER>
<TOP MID>
<BOT RIGHT>
<MID LEFT>
<TOP RIGHT>
<BOT MID>
<TOP LEFT>
<MID RIGHT>
<BOT LEFT>
Summary of Contents for TDM-243W
