C2-6104A O
PERATION
M
ANUAL
39
Enter 4 numbers one by one to form the IP address you wish to assign to the unit.
The IP address is a series of four numbers between 0 and 255. Anything above 255
is not a valid number in an IP address range. The unit will not allow you to go above
255.
The IP address must be a unique address on your network, and also must be within
the sub-net of your network. If you are unsure about which IP address to use or
don’t have a unique IP address, ask your Network Administrator.
Adjust the last 2 numbers to set the sub-net address (also know as sub-net mask)
of your network. Again, if in doubt ask your Network Administrator.
Enter your network’s gateway IP address into this menu item. Again, if in doubt ask
your Network Administrator. In general, the gateway only needs setting if the unit is
being controlled from a different network (e.g. via the internet).
Enter the IP port number you wish the unit to communicate on. Keep a note of this
as it will be needed when using other devices to communicate with the unit e.g. CC-
300.
Certain units require a re-boot once the new IP address has been entered. Once
activated, all current settings (including other menu items) will be saved and the unit
will re-boot. If you do not see this menu item, then your unit has already
implemented your changes and no re-boot is required.
8.11
Items associated with the Adjust resolutions group
The Adjust Resolutions Menu Group only appears when the
Advanced Menus function is turned on within the System Menu
Group. To turn it on, go to the System Menu Group and then
proceed to the item that says “Advanced Menus”. Turn the
function ‘On”, exit the Systems menu and return to this menu structure
.
The Resolution Database is used by your unit to identify any incoming video signal
and is also used to create an output resolution. It is therefore a very important part
of the unit’s infrastructure.
Important Cautionary Information
Adjust ethernet
IP sub. 255.255. [255.000]
Adjust ethernet
IP gtwy. [ 10] 1 2 123
Adjust ethernet
IP port [10001]
1A Adjust Ethernet
Set new IP data & reboot
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
