5
5.0
OPERATING THE UNIT
Before installation, please make sure all of devices have been turned off.
•
Connect your DVI display to the switcher’s DVI output with high quality cable
•
Connect two or four DVI-I sources to the switcher’s inputs (total depends on
switcher model) with high quality cable
•
Plug the 9 VDC Power Adapter into the rear of the unit
•
Plug the Power Adapter into a working AC socket
•
Power on all input and output devices
•
Select the DVI source you want to view as explained below
You can select the channels you want to access in two ways: front panel push button
selection or via the remote control included with the package content.
5.1
Front Panel Push Button Selection:
The front panel push button is used to select the channel to be displayed on the screen.
Pressing the button during normal operation will cause the next channel to be selected
in sequence.
5.2
Remote Control Selection:
The channel selection can also be made via the provided remote by pressing the
appropriate button.
Note: If you have a problem with the IR control conflicting with other devices, the remote
allows users to reconfigure four (A, B, C, D) alternate combinations of IR codes.
The default code is A.
Push and hold the IR code button (A, B, C or D) on remote control panel for 2 seconds.
The 7-segment LED display will show the IR code for one second when the new IR
code is set.
Note – The optional 1T-IRR-100 Remote IR Extender allows the Switcher to be placed
in a concealed location and still use the IR Remote Control. The IR Extender comes
with a 5’ cable with 3.5mm Mini connectors, but longer lengths can be used.
6.0 TROUBLESHOOTING
If the switcher does not appear to be functioning, make certain that all the DVI sources
and the DVI capable monitor are functioning correctly by connecting each DVI source in
turn directly to the monitor using a cable with a length of 6 feet or less. If the signal is
present under those conditions, make certain that the power is present on the switcher.
If it is, measure the cable length you are attempting to use between the sources to the
switcher and the switcher to the monitor. The cables must be 6 foot long or less. Lastly,
