Fig. 4.19
Fig. 4.18
Fig. 4.17
Fig. 4.20
l
Remove the CRR. pan head screws (4 nos.)
from the float chamber mounting and take out
the float chamber along with the gasket.
(Fig. 4.17)
Phillips head screw driver
Note:
While reassembling the float chamber,
inspect the condition of gasket float
chamber and replace if required.
l
Remove the pin float. (Fig. 4.18)
Nose plier
l
Take out the float along with the float needle
(needle valve assembly).
l
Using a small flat screw driver, carefully
remove pilot jet. (Fig. 4.19)
Flat screw driver (small)
Caution:
During reassembly of the pilot jet do not
tighten more than required as it may
damage the seating surface.
l
Remove main jet (A) while holding holder jet
needle. (Fig. 4.20)
Flat screw driver
l
Remove holder needle jet (B) and take out
needle jet.
7 mm spanner
Note:
The holder needle jet and the needle jet
need to be removed only if necessary.
TVS APACHE RTR 200
SERVICE MANUAL
FUEL, LUBRICATION AND
EXHAUST SYSTEM
4-7
A
B
